Bed Pooler| DIY Home

- Chosen by Voters buy a radio control for model air planes and use a servo to trigger it the person wants an answer Not a Lecture Source(s): old timer Edited 3 weeks ago 63% 5 Votes

- Chosen by Voters Double sided tape by Scotch 2 months ago 67% 2 Votes

- Chosen by Voters fix battens ( can be timber or steel) to the wall vertically at a spacing that is standard in your country.attach plaster board to battens.( this is a VERY rough how too)seasonal shift can crack your plaster if fixed straight to concrete, If worried make another internal wall right next to concrete wall and only fix it to the ceiling and the floor( dont attach it to the concrete)…if the concrete wall shifts then the internal frame wont.ANYTHING can be built Source(s): carpenter 3 weeks ago 67% 2 Votes

- Chosen by Voters That sound like it would be hard to do. Why don't you just put plastic sheeting under the rug? You can get it in different thicknesses. 1 week ago 100% 1 Vote 1 person rated this as good

- Chosen by Voters NO. You're putting 15A components unprotected behind a 30A. breaker. 2 months ago 67% 2 Votes 1 person rated this as good

I'm not quite sure what your looking to do. The magnetic ball could be caused to glide if the tape it was on happened to be an electromagnet. That is how mag-lift trains operate. 1 month ago 1 person rated this as good Thanks, whatever I tried to do worked.

- Chosen by Voters A washer less faucet is around $100 depending on what brand, how fancy you want, Source(s): maint man 2 months ago 100% 3 Votes

I call them Hammer Downs , or thresholds strips, or brass carpet edging, 2 months ago 5 people rated this as good thank you for the quick answer

- Chosen by Voters Whenever you provide the labor in any type of renovation, you will save money. Removing carpeting is not rocket science, but there are some things you should know.I don't know how big your room is, but if you cut your carpet into 4 foot strips, it will be easier to carry out. Your local hardware store sells hooked blades for utility knives, that are designed for cutting carpet. You might also get lucky by starting a cut, then tearing the carpet the rest of the way. Break the carpet loose from the tack strips at a corner and go from there.Once the carpet and padding are removed, you'll have to go around with a pair of pliers and/or a screwdriver and remove all the staples from the floor. You'll also need to remove the tack strips around the perimeter of the room. BE CAREFUL, these have nail points sticking up. Use a screwdriver and/or a pry bar to pry them off the floor. Don't grab them with your hands! Make sure you pull all the nails from the tack strips. Source(s): Experience 1 month ago 100% 1 Vote

- Chosen by Voters nasty job ahead of you…the staples are likely to ruin the scraper…i usually hire a few day laborers , give them 100 each, buy them some lunch and take it from there… 2 months ago 100% 2 Votes